The Motorola authorized distributor mobile parts are sim tray has been removed you need to place a plastic pry tool in between the back housing. The frame of the screen and then you’re going to run it along the edges and pop off the catches. Now before you can completely lift up and remove the back housing there is adhesive around the fingerprint reader and around. Which need to be removed once the screws are removed. We can lift up and remove the plastic cover on the top plastic cover your lens cover for the camera is located. Over here and if that ever breaks you can just apply some heat, which will loosen up the adhesive and you can that glass portion off now it’s time to disconnect the Motorola authorized distributor parts and battery cable now that we’ve disconnected the battery cable we can go ahead and disconnect the rest of the cables there’s a wire cable over here in the corner that needs to be popped off there’s also a copper tape over here which needs to be peeled off in order to be able to disconnect. The front-facing camera cable the flex cable over here in the corners for your volume key and power button and there’s a latch or lock over here which needs to be lifted up to release it once that’s unlocked you can slide it out there are two more.
The Motorola Mobile Phone Authorized Distributor:
The Motorola authorized distributor screws which need to be removed one located over here and one over here now the mainboard can be lifted up and removed on the front of the main board there’s a liquid damage indicator located over here which is that white sticker your headphone jack is over here. There’s a secondary microphone located right here the led flash is located right over here and there’s that the phone Motorola authorized distributor is being charged so basically when the phone is completely drained and when you plug it in the screen can’t display anything because there’s not enough power that light is to notify you that the phone is actually being charged there’s some more graphite film over here on top of this shield once the shields are removed we can see some thermal pads which sit on top of the processor and memory as well as the chip over here the speaker assembly can be lifted up and removed and here’s a better look at that there’s a flex cab over here that needs to be disconnected as well as a wire cable over here which needs to be popped off there’s one screw over here holding down the sub board or charger port board once that screw is removed we can lift up and remove the charger part board the main microphone is located over here and there’s a rubber gasket on the charger port and get some along the edges of the battery and let it sit there for about a minute so it eats away at the adhesive underneath making it easier to pry the battery off here’s a better look at the battery Motorola authorized distributor once the battery is removed we can see the flex clip over here which connects to your screen and the sub board over here so if you have to replace your screen at this point you would have to heat up the front of the phone where the screen is so you can lose some adhesive underneath and then you would pry your screen off making sure you run this Motorola authorized distributor flex cable over here through the opening as well as this one over here get your new screen apply new adhesive and run those cables back through the openings and just reassemble your phone your vibrator motor is located over here in the bottom.
